|
DHB-103 DomoClick T derivation |
|
|
|
DHB-103 DomoClick® T derivation set for the junction between three heating tapes (for example for a T derivation or extending a circuit T derivation 2 terminals 3 heat-resistant ligatures 3 stirrups for wall mounting self-adhesive labels “electric supply” and “terminal”
 Doing the job
Box and cover in polyamid Ligature Incorporated electrical connection including cablegland PG 16 for DHB 100, DHB 102 and DHB 104 Stirrups for wall mounting CE
Installation prescriptionsThe installation of bands, connections to DomoClick® connectors to connection boxes will be carried out according to the rules of the trade. Before going ahead with work on electric tracers, care will be taken to isolate them from the mains. The DomoClick® connection and junction techniques are approved if used together with self-adjusting Eltrace heating tapes. Eltrace guarantees correct working only in relation with the mentions heating tapes. Through the direct mounting onto the pipe, DomoClick® uses less heating tape. As a general rule, DomoClick® is fixed to the pipe with the supplied ligatures. DomoClick® can also be fixed to the wall with supplied stirrups. The supply cable is to bedirectly connected into the DomoClick®. Any exterior supply, junction or derivation box is thus avoided. In anti-frost installations for gutters, DomoClick® must not be installed in a gutter or on the roof, but in a sheltered position under the rroof or eave DomoClick® can be installed directly on pipes with a service temperature of less than 70°C. Short periods at 80°C are admitted. Important : for admitted temperatures of heating tapes, refer to the technical data DomoClick® incorporated into pipe insulation. All supply points, junctions and terminals must remain accessible. Electrical supply points and terminals must be indicated with the supplied self-adhesive labels.
|
