constant power HEATING tape ELP-E

LCIE 02 ATEX 6203 X

Adjustable in length on site, packed in rolls, eltrace parallel heating tapes type ELP-E represent a saving in installation and design time.

Applications :Protection from freezing and maintained temperature of pipes and tanks. Maintained temperature in explosive areas in the chemical and petrochemical industry. Protection against freezing of condensation or steam purge lines. Maintained temperature of flexible lines for gas an analyzers.

Avantages : Storage in rolls, Finishing on site, Built-in cold terminations, High resistance to corrosion, High maintained temperatures, High safety thanks to modular design.

Specification:

• Size : 7,3 × 5 mm
• Bus wires : 2 × 2 mm²
• Insulation :  silicon - 0,9 mm
• Heating wire : nickel-chrome
• Outer sheath : FEP - 0,5 mm 
• Braid (*) : tinned copper (0.07 W/m) or
•                   stainless steel (0.6 W/m)
• Covering factor : 70%
• Over sheath (*) : FEP - 0,4 mm
• Power supply : 230 or 400 volts
• (*) Options 

Maintained temperature of pipes and tanks up to 200°C in healthy, corrosive or explosive atmosphere. Approved by LCIE No. 96.D.6119X.

Modèle	Puissance	Tension	T° maxiHors tension	T° maxi sous tension	Module	Long. Maxi
ELP-E-10	10 W/m	230 V	200°C	150°C	1,2 m	50°C : 150 m 100°C : 146 m
ELP-E-20	20 W/m	230 V	200°C	125°C	1 m	50°C : 105 m 100°C :   95 m
ELP-E-30	30 W/m	230 V	200°C	110°C	1 m	50°C :   85 m 100°C :   78 m
ELP-E-10-3	10 W/m	400 V	200°C	150°C	2 m	50°C : 255 m 100°C : 235 m
ELP-E-20-3	20 W/m	400 V	200°C	125°C	1,4 m	50°C : 180 m 100°C : 166 m
ELP-E-30-3	30 W/m	400 V	200°C	110°C	1,2 m	50°C : 147 m 100°C : 135 m

 Hazard area :          II CT3 - T4 - T5 or T6Maximum power :  T3 = 35 W/m  ; T4 = 18 W/m ; T5 = 10 W/m ; T6 = 7 W/m

Min. curve radius : 15 mm.

Recommend this article...